This pair of tenders for the South Arkansas Fire Protection District is built on International 7500 chassis equipped with 4-wheel drive and powered by an International Maxxforce 9 330hp diesel engine with an Allison Automatic Transmission.  The lower skirting body and compartments is constructed from all aluminum with aluminum Gortite roll up doors.  The pump compartment is located at the front of the apparatus body under the front upper portion of the water tank.  The pump is a Waterous CXVPA 750GPM PTO pump capable of “pump and roll” operations along with stationary pumping operations.  There is an Akron Fire Fox remote controlled monitor at the front bumper of the apparatus with Joystick control located in the cab adjacent to the driver seat.   There is also one (1) 2” discharge plumbed to the front bumper which tee’s into one (1) 1 ˝” and 1” in two (2) separate hose beds in the front bumper extension.  The apparatus is also equipped with a Waterous AQUIS 2.5 foam injection system with an integral 30-gallon foam cell in the water tank.  The water tank is a United Plastics Fabricating Poly Wet-Side tank with a 2000-gallon capacity.  The tank is equipped with two (2) Newton electrically actuated dump valves and extension chutes with controls at the rear and in the cab. One (1) dump is at the rear center and the other is at the driver side rear.  The tank is also equipped with one (1) 2 ˝” direct tank fill at the rear panel.  There is hard suction hose storage at the left side of the apparatus and a manual folding tank bin at the right side of the apparatus body.  The warning light package is an all Whelen Super LED package with halogen 12-volt scene lights on the tank and rear panel.  There are additional scene lights at the front bumper extension ends and a Fire Research Focus 12-volt brow light at the top of the lightbar for enhanced safety during low light and dark pump and roll operations.